Sharper Image Baby Accessories IB ECB100 User Manual

ONE YEAR LIMITED WARRANTY  
SI PRODUCTS sells its products with the intent that they are free of defects in manufacture and  
workmanship for the life of the original purchaser from the date of original purchase, except as noted  
below. SI PRODUCTS warrants that its products will be free of defects in material and workmanship  
under normal use and service. This warranty extends only to consumers and does not extend to  
Retailers.  
To obtain warranty service on your SI PRODUCTS product, mail the product and your dated sales  
receipt (as proof of purchase), postpaid, to the following address:  
SI PRODUCTS Consumer Relations  
Service Center Dept. 168  
3000 Pontiac Trail  
®
Sound Soother  
20 Soothing Sounds  
Commerce Township, MI 48390  
No COD's will be accepted.  
SI Products  
Service Center  
SI PRODUCTS does not authorize anyone, including, but not limited to, Retailers, the subsequent  
consumer purchaser of the product from a Retailer or remote purchasers, to obligate SI PRODUCTS  
in any way beyond the terms set forth herein. This warranty does not cover damage caused by  
misuse or abuse; accident; the attachment of any unauthorized accessory; alteration to the product;  
improper installation; unauthorized repairs or modifications; improper use of electrical/power supply;  
loss of power; dropped product; malfunction or damage of an operating part from failure to provide  
manufacturer’s recommended maintenance; transportation damage; theft; neglect; vandalism; or  
environmental conditions; loss of use during the period the product is at a repair facility or otherwise  
awaiting parts or repair; or any other conditions whatsoever that are beyond the control of SI  
PRODUCTS.  
This warranty is effective only if the product is purchased and operated in the country in which the  
product is purchased. A product that requires modifications or adoption to enable it to operate in any  
other country than the country for which it was designed, manufactured, approved and/or authorized,  
or repair of products damaged by these modifications is not covered under this warranty.  
THE WARRANTY PROVIDED HEREIN SHALL BE THE SOLE AND EXCLUSIVE WARRANTY. THERE  
SHALL BE NO OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF  
MERCHANTABILITY OR FITNESS OR ANY OTHER OBLIGATION ON THE PART OF THE COMPANY WITH  
RESPECT TO PRODUCTS COVERED BY THIS WARRANTY. SI PRODUCTS SHALL HAVE NO LIABILITY FOR  
ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO EVENT SHALL THIS WARRANTY  
REQUIRE MORE THAN THE REPAIR OR REPLACEMENT OF ANY PART OR PARTS WHICH ARE FOUND TO  
BE DEFECTIVE WITHIN THE EFFECTIVE PERIOD OF THE WARRANTY.  
1.888.856.6781  
8:30a.m. – 7:00p.m. (EST)  
M – F  
Mail To: SI Products  
Consumer Relations  
Service Center Dept. 168  
3000 Pontiac Trail  
Commerce Township, MI  
48390  
e-mail:  
NO REFUNDS WILL BE GIVEN. IF REPLACEMENT PARTS FOR DEFECTIVE MATERIALS ARE NOT  
AVAILABLE, SI PRODUCTS RESERVES THE RIGHT TO MAKE PRODUCT SUBSTITUTIONS IN LIEU OF  
REPAIR OR REPLACEMENT.  
This warranty does not extend to the purchase of opened, used, repaired, repackaged and/or resealed  
products, including but not limited to sale of such products on Internet auction sites and/or sales of  
such products by surplus or bulk resellers. Any and all warranties or guarantees shall immediately  
cease and terminate as to any products or parts thereof which are repaired, replaced, altered, or  
modified, without the prior express and written consent of SI PRODUCTS.  
This warranty provides you with specific legal rights. You may have additional rights which may vary  
from state to state. Because of individual regulations, some of the above limitations and exclusions  
may not apply to you.  
For service or repair - do not return this unit to the retailer.  
Contact SI PRODUCTS Consumer Relations at 1-888-856-6781.  
©The Sharper Image. All rights reserved. THE SHARPER IMAGE name and logo are registered  
trademarks.  
Instruction Manual and  
Warranty Information  
EC-B100  
©2009 THE SHARPER IMAGE and its affiliated companies, all rights reserved. THE SHARPER IMAGE is a  
registered trademark of THE SHARPER IMAGE and its affiliated companies. All rights reserved.  
IB-ECB100  
 
Sound Soother® Features:  
20 Digitally Recorded Sounds: Aviary, Brook, City, Dockside, Ebb Tide,  
Everglades, Fireside, Foghorns, Heartbeat, North Woods, Oceanside, Rain,  
Rainforest, Roadside, Steam Train, Summer Night, Surfs Up, Thunderstorm,  
White Noise, Wind Chimes.  
Easy-to-read illuminated LCD with white backlight displays time & sound name  
Dual Alarm Clock for individual wake times  
Choice of two Alarm Wake Modes: Soothing Sounds or Beep Tone  
Snooze automatically set for nine minutes for extended sleep  
Digital volume control adjusts the volume of your sound selection  
2-pc speaker included (2.5” in diameter)  
Powered by 3V DC (a total of 3 (three) AA batteries (not included)) or 6V  
300mA (120V input ) AC/DC adaptor (included)  
Battery installation:  
Alarm clock uses an AC adaptor (included) or 3 (three) AA batteries  
(not included).  
The battery power is designed only to provide MEMORY BACK-UP for the clock  
and alarm settings. Three AA batteries (not included) should be inserted following  
the polarity marked in the battery compartment if memory back-up is desired (in  
the event of power outages or if the unit is unplugged). However, the time will  
not be illuminated on the clock display. As soon as the power supply returns, the  
display will indicate the correct time.  
NOTE: Battery must be installed in order for clock memory back-up to operate.  
In the event of a power failure or disconnection, if the battery is not installed, the  
clock and alarm will need to be re-set when power is restored.  
Fig. 1  
 
5
4
Choosing the Sound Selection:  
Battery Precautions  
1. Press the POWER button.  
Use only the size and type of batteries specified.  
2. Press the right side of the MUSICAL NOTE “>” button for the next nature  
sound (short press). Long press and hold to fast forward.  
3. Press the left side of the MUSICAL NOTE “<” button for previous nature sound  
(short press). Long press and hold to go backwards quickly.  
(Refer to Fig.2)  
When installing batteries, observe proper +/- polarities. Incorrect installation of  
battery may cause damage to the unit.  
Do not mix different types of batteries together (e.g., alkaline with carbon-zinc  
or old batteries with new ones).  
If the unit is not going to be used for a long period of time, remove batteries to  
prevent damage due to possible battery leakage.  
NOTE: The digital display should show the sound number with the respective  
Do not dispose of batteries in fire. Batteries may explode or leak.  
sound name.  
POWER:  
Volume Control:  
Plug adapter into a 120V AC outlet and plug the receptacle end into the input jack  
on the back of the unit. Press the POWER button (located center of top panel) to  
turn the sound on or off.  
Press “+” to increase the volume level.  
Press “-“ to decrease the volume level.  
Setting the Clock:  
1. Long press and hold the DATE/TIME SET button (for more than 3 seconds)  
and press “+” and “-“ to “INCREASE” (+) and “DECREASE” (-) to the time you  
desire. Press it again once to set Year > Month > Day > Hour > Minute > Exit.  
NOTE: AM/PM choice will be made at this time.  
2. Short press DATE/TIME SET button once, it will display the date. Press twice,  
it will display the time. Normal time display will return after 5 seconds.  
(Refer to Fig.2)  
Fig. 2  
6
 
7
al 2 Button  
Setting and Using the Alarm:  
For your convenience, two separate alarms may be set to accompany individual  
wake-up times.  
Short press the al2 button: Set Alarm mode, Beep, Sound, Off  
The alarm 2 bell icon will appear next to the selected mode when alarm is set.  
Press and hold the al 2 button:  
1. The “ALARM 2” icon illuminates, time flashes for hour (HH), press “-/+“  
button to change hour setting.  
al 1 = “Alarm 1”  
al 2 = “Alarm 2”  
(Refer to Fig.2)  
2. Press Alarm 2 button to confirm and change to minute setting. Time  
flashing for minutes (MM), press “-/+“ button to change Minute setting, wait  
for timeout to save and go back to normal mode.  
3. The digital display will then show “ALARM 2” icon after you have  
successfully set the ALARM 2 time.  
al 1 Button  
Short press al 1 button: Set Alarm mode, Beep, Sound, Off  
The Alarm 1 bell icon will appear next to the selected mode when alarm is set.  
Press and hold the al 1 button:  
1. The “ALARM 1” icon illuminates, time flashes for hour (HH), press “-/+“ button  
to change HOUR setting.  
Snooze:  
2. Press Alarm 1 button to confirm and change to the minute setting. Time  
flashes for minutes (MM), press “-/+“ button to change MINUTE setting, wait  
for timeout to save and go back to normal mode.  
3. The digital display will then show “ALARM 1” icon after you have successfully  
set the ALARM 1 time.  
When the alarm sounds, press the SNOOZE/TIMER button to snooze. This will  
automatically activate snooze time for nine minutes. Press the POWER button  
to turn snooze off.  
Timer:  
When the power is on and you are listening to a nature sound, you may set a  
timer so the unit will automatically turn off.  
1. Toggle through the SNOOZE/TIMER button until you find the time of your  
choice, 15, 30, 45 or 60 minutes.  
2. To cancel the timer, toggle through the SNOOZE/TIMER button until the  
LED light says “OFF” or press POWER.  
(Refer to Fig.2)  
 
9
8
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to which  
the receiver is connected.  
Settings located on back:  
DC IN:  
DC Jack for adaptor plug-in.  
Consult the dealer or an experienced radio/TV technician for help.  
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR  
TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS  
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO  
OPERATE THE EQUIPMENT.  
Daylight Savings Time:  
Slide the DST ON/OFF button to activate or inactivate the Daylight Savings Time  
feature, which will automatically adjust for Daylight Savings Time.  
BACKLIGHT:  
Choose between three settings of brightness on your display: HI, MED or LO.  
Maintenance  
To Store  
You may leave the unit on display, or you can store it in its box in a  
cool, dry place.  
To Clean  
Use only a soft dry cloth to clean the enclosure of the unit.  
NEVER use liquids or abrasive cleaner to clean.  
Modifications not authorized by the manufacturer may void user warranty.  
Note: This equipment has been tested and found to comply with the limits  
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses  
and can radiate radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try to correct  
the interference by one or more of the following measures:  
Reorient or relocate the receiving antenna.  
 
11  
10  

Sharp Cash Register ER A450T User Manual
Sharp CRT Television LC 46LB700X User Manual
SIIG Work Light 04 0918A User Manual
Sony Car Stereo System MDX 66XLP User Manual
Sony Cassette Player WM FX244 User Manual
Sony Flat Panel Television 22BX320 User Manual
Sony Projection Television KV 30HS510 User Manual
Speco Technologies Security Camera CVC6246IHR User Manual
Targus Computer Drive 410 2366 203A ACH120EU User Manual
T Mobile Cell Phone MDA III User Manual