Rimage Printer 110660 001_F User Guide

Rimage AutoEverest AutoPrinter™  
Setup and Installation Guide  
2
Prepare the Everest  
Voltage Switch  
a. Unpack the Everest printer.  
Refer to the label on the  
Everest printer box.  
Before you begin:  
This document is intended for people who are familiar with hardware setup, software  
installation, and Windows operating systems.  
b. Follow the instructions on the  
instruction card on the rear  
of the printer.  
i.  
Set the AC voltage  
switch.  
If you do not understand the procedures in this document, ask your computer  
technician for help.  
Instruction Card  
Shipping Screw  
ii. Move the shipping  
screw to the storage  
position.  
Shipping Screw  
Storage Position  
This document describes how to set up your Rimage AutoEverest AutoPrinter. If you  
are using the Everest printer as a standalone printer or with an autoloader, refer to the  
printer or autoloader’s setup and installation instructions.  
Documents referenced in this procedure shipped with your product and are also  
available online at www.rimage.com/support. Select: Printer Series > AutoPrinter >  
User Manuals tab.  
Side Cover Latches  
c. Open the Everest printer.  
i.  
Press the two side cover latches.  
- Important!  
ii. Lower the side cover.  
Read all setup instructions thoroughly before you begin.  
Save all packing boxes and packing materials for your AutoPrinter and  
Everest printer.  
Note: Your product may not look exactly like the product pictured.  
# Required tools: Scissors or side cutters  
d. Open latches 1, 2, and 3 as indicated  
by the arrows.  
1 Prepare the AutoPrinter  
a. Cut the plastic tie wraps (Qty. 2) from  
Latch 1  
Latch 2  
Latch 3  
the lift arm.  
n Caution! Do not cut the belt or  
Tie  
Wraps  
the cable!  
e. Remove the plastic packing  
pieces (Qty. 2) from inside the  
printer.  
b. Remove the shipping foam inserted  
above the carousel.  
Shipping  
Foam  
f. Install the print ribbon and  
retransfer ribbon. Refer to  
the instruction label on the side  
cover, or refer to the Everest  
Printer User Guide.  
Plastic Packing Pieces  
110660-001_F  
Copyright © 2009 Rimage Corporation  
Page 1  
 

Radio Shack Home Security System 49 421A User Guide
Rayburn Cooktop 200SFW User Guide
Remington Styling Iron S 8000i User Guide
Roland Drums HD 3 User Guide
Ryobi Drill HP472 User Guide
Samsung Speaker System DA E570 User Guide
Samsung Tablet GT N5110 User Guide
Sanyo Digital Camera S770 User Guide
Sanyo Digital Camera VPC J1EX User Guide
Saturn Automobile 2008 Vue User Guide