Hasbro Robotics 85412 User Manual

VOICE SWITCH  
AGES 5  
The voice switch has 3 different settings and a “demo” setting. This toy is  
packaged in the “demo” setting for in-store demonstration purposes. You  
will need to slide the switch to any of the other 3 settings for full activation of  
the features. NOTE: Speech function is disabled in “demo” setting.  
through adult  
The mechanism helps you sound like Darth Vader.  
VoIcE SWITcH (Front View)  
To make your voice sound even more like Vader’s,  
try this while using the toy:  
Choose a setting: The 3 settings alter your  
voice in different ways. Try each setting to see  
which one makes your voice sound closest to  
"DEMo"  
SETTING #1  
SETTING #2  
SETTING #3  
the way Darth Vader sounds.  
Listen to the actual phrases to learn the pace  
at which Darth Vader speaks.  
Deepen your voice as you talk.  
Talk slowly and clearly.  
Speak into the microphone and get your mouth as close to the  
microphone as possible.  
VOICE BUTTON  
Wearing the helmet and chestplate, press the Voice Button and speak. Your  
voice will change, to sound like Darth Vader’s! See the above instructions on  
settings and voice adjustment to fine-tune the sound.  
PHRASES BUTTON  
Wearing the helmet and chestplate, press the Phrase Buttons to hear Darth  
Vader’s actual phrases from the movies!  
The phrases are: “You don’t know the power of the dark side.”  
“There is no escape.”  
BREATHING BUTTON  
PHRASES BUTTON  
VOICE BUTTON  
“The Force is with you.”  
“Your powers are weak.”  
“Don’t make me destroy you.”  
BREATHING BUTTON  
Wearing the helmet and chestplate, press the Breathing Button to hear Darth  
Vader’s actual breathing sounds from the movies!  
1.5VAA/R6 size  
x3  
BATTERIES INCLUDED  
Replace with 3 x 1.5V “AA” or R6 size batteries.  
Alkaline batteries recommended. Phillips/cross  
head screwdriver (not included) needed to  
replace batteries.  
Product and colors may vary.  
VOICE  
© 2007 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved.  
®* and/or ™* & © 2007 Hasbro. All Rights Reserved.  
® denotes Reg. U.S. Pat. & TM Office.  
*
85412  
SWITCH  
*
(See inset above)  
IMPORTANT! PLEASE READ INSTRUCTIONS COMPLETELY BEFORE WEARING TOY.  
TO REPLACE BATTERIES  
IMPORTANT:BATTERY INFORMATION  
Loosen screw in battery compartment door with a Phillips/cross head  
screwdriver (not included). Remove door. Remove and discard batteries. Insert  
3 x 1.5V “AA” or R6 size batteries. Alkaline batteries recommended. Replace  
door, and tighten screw.  
Please retain this information for future reference.  
Batteries should be replaced by an adult.  
BAcK  
!
CAUTION:  
1. Always follow the instructions carefully. Use only batteries  
specified and be sure to insert them correctly by matching the +  
and – polarity markings.  
2. Do not mix old batteries and new batteries, or standard (carbon-  
zinc) with alkaline batteries.  
3. Remove exhausted or dead batteries from the product.  
4. Remove batteries if product is not to be played with for a long  
time.  
FRoNT  
ADJUSTABLE STRAPS  
5. Do not short-circuit the supply terminals.  
The mask has adjustable straps on the front, sides and back. To adjust,  
lift straps off posts, slide straps to desired position, and press straps  
onto posts.  
6. Should this product cause, or be affected by, local electrical  
interference, move it away from other electrical equipment.  
Reset (switching off and back on again or removing and re-  
inserting batteries) if necessary.  
7. RECHARGEABLE BATTERIES: Do not mix these with any  
other types of battery. Always remove from the product before  
recharging. Recharge batteries under adult supervision. DO NOT  
RECHARGE OTHER TYPES OF BATTERIES.  
TAB  
HEADGEAR  
PRESS IN To lATcH  
RIB  
Pull ouT To uNlocK  
cHESTPlATE  
FCC Statement:  
This equipment has been tested and found to comply with the limits  
for a Class B digital device, pursuant to part 15 of the FCC Rules.  
These limits are designed to provide reasonable protection against  
harmful interference in a residential installation. This equipment  
generates, uses and can radiate radio frequency energy, and, if not  
installed and used in accordance with the instructions, may cause  
harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation. If  
this equipment does cause harmful interference to radio or television  
reception, which can be determined by turning the equipment off and  
on, the user is encouraged to try to correct the interference by one or  
more of the following measures:  
!
CAUTION:  
TO AVOID BATTERY LEAKAGE  
1. Be sure to insert the batteries correctly and  
always follow the toy and battery manufacturers’  
instructions;  
2. Do not mix old and new batteries or alkaline,  
standard (carbon-zinc) or rechargeable (nickel-  
cadmium) batteries;  
MASK  
1.  
2.  
WEARING HELMET  
3. Always remove weak or dead batteries from the  
Place mask on face. Place headgear straight down on head, aligning rib  
inside headgear with indentation on back of mask. Slide headgear forward  
until you hear a click (tab on front of headgear will lock into slot between  
the eyes in the mask). To remove headgear, lift tab on front of headgear.  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and receiver.  
• Consult the dealer or an experienced radio/TV technician for help.  
product.  
 

Grizzly Guitar H6085 User Manual
Grizzly Saw G0588 G0591 User Manual
Honeywell Clock TE219ELW User Manual
Hoshizaki Ice Maker KML 250MAH User Manual
Hotpoint Dishwasher LFT04 User Manual
HP Hewlett Packard Printer 110plus User Manual
HP Hewlett Packard TV Converter Box 70900A User Manual
HP Hewlett Packard TV Video Accessories TS5220 User Manual
HP Hewlett Packard Water Dispenser 8568B User Manual
Hunter Fan Outdoor Ceiling Fan 23488 23489 User Manual