Harbor Freight Tools Film Camera 90850 User Manual

35 MM OUTDOOR CAMERA  
90850  
OPERATING INSTRUCTIONS  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Copyright © 2003 by Harbor Freight Tools®. All rights reserved. No portion of this  
manual or any artwork contained herein may be reproduced in any shape or  
form without the express written consent of Harbor Freight Tools.  
For technical questions and replacement parts, please call 1-800-444-3353  
 
Operation  
Loading the Camera  
Note: Load and unload the film only in low light or shade. Bright light can damage the film  
whether it is exposed or unexposed.  
1.  
2.  
Open the back of the Camera by pushing down on the latch on the left side of the back  
cover. Put the roll of film (not included) in the slot on the left side of the Camera.  
Stretch the film over to the take-up spool making sure that the sprocket holes on the  
film fit onto the teeth across the bottom/middle of the Camera. Insert the end of the  
film through the slot on the take-up spool.  
See FIGURE 1.  
3.  
Wind the film by turning the center Knob from left to right slightly, to make sure that it  
catches, then close the back of the Camera. Wind, using the center Knob until it stops,  
and click the Trigger Button. Repeat 2-3 times until the film is past the exposed portion.  
Shooting the Camera  
1.  
Turn the center Knob from left to right until it stops. Hold the Camera steady (using  
both hands) making sure your finger is not in front of the lens.  
Look through the Viewfinder and center your object. Gently push the Trigger Button.  
See FIGURE 1.  
2.  
Unloading the film (not included)  
Note: When the counter on the bottom of the Camera indicates you have shot your last  
picture, you must rewind the film before opening the Camera or you will expose and  
ruin the film.  
1.  
Unlock the film release by pushing and holding in the button on the bottom of the  
Camera, under the Knob. Flip the Handle up on the Rewind Dial and turn it clockwise  
(as indicated on the dial) until you hear and feel that the entire roll is back in side the  
film cartridge (Approximately 60 turns). See FIGURE 1.  
2.  
Open the back of the Camera by pushing down on the latch on the left side of the back  
cover. Unload the Camera.  
FIGURE 1  
Trigger  
Button  
Rewind Handle  
Viewfinder  
Lens  
(Inside)  
Take-up  
Spool  
Teeth  
Film Release Button  
Knob  
Loading Slot  
Page 3  
SKU 90850  
 

H2O Audio Carrying Case iFP 700 User Manual
Honeywell Cooktop Central Heating Cooker Natural Gas User Manual
Hotpoint Washer Dryer WMA30 User Manual
Hotpoint Washer Dryer WMUD 943 User Manual
Hotpoint Washer HAULT 943 User Manual
HP Hewlett Packard Digital Camera M307xi User Manual
Hughes Kettner Stereo Amplifier TrilogyTM User Manual
Husqvarna Snow Blower 15530SB LS User Manual
Hypertec Carrying Case N16348NHY User Manual
iHome Universal Remote RZ2 User Manual