P3PC-E862-01XA
fi-434PR Imprinter
User's Guide: Option
English
User's Guide
Japanese
fi-434PR Imprinter
User's Guide: Option
English
FCC Declaration:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTICE
• The use of a non-shielded interface cable with the referenced device is prohibited. The length of the parallel interface
cable must be 3 meters (10 feet) or less. The length of the serial interface cable must be 15 meters (50 feet) or less.
• The length of the power cord must be 3 meters (10 feet) or less.
ICES:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conformme à la norme NMB-003 du Canada.
Energy Saving:
As an ENERGYSTAR ® Partner, PFU Limited has determined that this scanner meets ENERGYSTAR ® guidelines for energy
efficiency. ENERGYSTAR ® is a U. S. registered mark.
High Safety Required Use:
The Product is designed, developed and manufactured as contemplated foe general use, including without limitation,
general office use, personal use and household use, but is not designed, developed and manufactured as contemplated
for use accompanying fatal risks or dangers that, unless extremely high safety is secured, could lead directly to death,
personal injury, severe physical damage or other loss (hereinafter "High Safety Required Use"), including without
limitation, nuclear power core control, airplane control, air traffic control, mass transport operation control, life support,
weapon launching control. The Customer shall not use the Product without securing the sufficient safety required for
the High Safety Required Use. In addition, Fujitsu (or other affiliate's name) shall not be liable against the Customer
and/or any third party for any claims or damages arising in connection with the High Safety Required Use by the
Customer of the Product.
• The contents of this manual may be revised without prior notice.
• We are unaccountable for any damages or passive damages from the use of this equipment or this manual and
any compensation of third party.
• The details of warranty is described in the warranty document pre-packaged.
All Rights Reserved, Copyright © PFU LIMITED 2001
2
FUJITSU Group Offices
Please send your comments on this manual or on PFU products to the following addresses:
PFU LIMITED
FUJITSU ICL ESPAÑA, S.A.
Camino Cerro de los Gamos, 1 28224, Pozuelo de Alarcon,
Madrid, Spain
Computer Products Business Group
658-1 Tsuruma Machida-shi, Tokyo 194-8510, Japan
Phone: (81-42)796-5211
Phone: (34-91)784-9000
Fax: (81-42)788-7651
Fax: (34-91)784-9317
E-mail: [email protected]
E-mail: [email protected]
Corporate headquarters
Australia
Nu 98-2 Unoke, Unoke-machi, kahoku-gun,
Ishikawa 929-1192, Japan
Phone: (81-76)283-1212
FUJITSU AUSTRALIA LTD.
2 Julius Avenue North Ryde, N.S.W 2113 Australia
Phone: (61-2)9776-4555
Fax: (61-2)9776-4556
Fax: (81-76)283-4689
CompuServe: GO FUJITSU
North America
FUJITSU COMPUTER PRODUCTS OF AMERICA, INC.
2904 Orchard Parkway, San Jose, California CA95134-2009,
U.S.A.
Phone: 1-800-591-5924;(1-408)432-6333
Technical Assistance Center: (1-800)626-4686
Fax: (1-408)894-1709
Asia
FUJITSU COMPUTER (SINGAPORE) PTE. LTD.
20 Science Park Road, #03-01, Tele Teck Park Singapore
Science Park II, Singapore 117674
Phone: (65)777-6577
Fax: (65)771-5499
E-mail: [email protected]
E-mail: [email protected]
FUJITSU CANADA, INC.
2800 Matheson Boulevard East, Mississauga, Ontario L4W
4X5, Canada
Phone: (1-905)602-5454
Fax: (1-905)602-5457
FUJITSU TAIWAN LTD.
19th Fl., No39, 1 Sec. chung-Hwa Rd., Taipei, Taiwan R.O.C.
Phone: (886-2)2311-2255
Fax: (886-2)2311-2277
E-mail: [email protected] (for sales questions)
FUJITSU HONG KONG LTD.
10/F., Lincoln House, 979 King’s Road, Taikoo Place, Island
East, Hong Kong
Europa
Phone: (852)2827-5780
FUJITSU EUROPE LTD.
Fax: (852)2827-4724
Hayes Park Central, Hayes End Road, Hayes Middlesex UB4
8FE, England
E-mail: [email protected]
Phone: (44-208)573-4444
Fax: (44-208)573-2643
E-mail: [email protected]
FUJITSU SYSTEMS BUSINESS (THAILAND) LTD.
12th Fl., Olympia Thai Tower, 444 Rachadapisek Road,
Samsennok, Huay kwang, Bangkok 10320, Thailand
Phone: (662)512-6066
Fax: (662)512-6068
FUJITSU DEUTSCHLAND GMBH.
Frankfurter Ring 211, 80807 München 40, Germany
Phone: (49-89)323-78-0
Fax: (49-89)323-78-100
E-mail: [email protected]
FUJITSU KOREA LTD.
5-11 Fl., Coryo Finance Center Building, Youido-Dong 23-6,
Young DungPo-gu, Seoul, Korea, 150-010
Phone: (82-2)3787-5970
Fax: (82-2)3787-6070
E-mail: [email protected]
FUJITSU NORDIC AB
Kung Hans Väg 12, S-192 68 Sollentuna, Sweden
Phone: (46-8)626-45-00
Fax: (46-8)626-45-88
FUJITSU SYSTEMS BUSINESS (MALAYSIA) SDN, BHD.
Fujitsu Plaza 1A, Japan Tandang 204, P.O.Box 636, Jalan
Sultan, 46770, Petaling Jaya Selangor Darul Ehsan, Malaysia
Phone: (60-3)793-3888
FUJITSU ITALIA S.p.A.
Fax: (60-3)7783-0888
Via Nazario Sauro, 38 20099 Sesto San Giovanni (Milan), Italy
Phone: (39-02)26294-1
FUJITSU PHILIPPINES, INC
Fax: (39-02)26294-201
2nd Fl., United Life Building, Pasay Road, Legaspi Village
Makati, Metro Manila, Philippines
Phone: (63-2)812-4002
FUJITSU FRANCE S.A.
Fax: (63-2)817-7576
1, Place des Etats-Unis, Silic 310, 94588 Rungis Cedex, France
Phone: (33-1)41-80-38-88
Fax: (33-1)41-80-3850
3
Table of Contents
❑ Introduction .......................................................................................................................................... 5
Conventions ..................................................................................................................................... 5
❑ 1. Components of the Imprinter ......................................................................................................... 6
❑ 2. Installation....................................................................................................................................... 7
(1) Installing the Imprinter ................................................................................................................. 7
(2) Mounting the Clamps ................................................................................................................... 8
(3) Mounting the Print Cartridge ........................................................................................................ 9
(4) Operation Test........................................................................................................................... 10
(5) Installing the Firmware and Device Driver ................................................................................. 11
❑ 3. Operation....................................................................................................................................... 11
(1) Replacing the Print Cartridge ..................................................................................................... 11
(2) Reset of the Ink Remain Counter............................................................................................... 12
(3) Clearing Paper Jam ................................................................................................................... 13
(4) Clearing the Nozzle Surface of the Print Cartridge..................................................................... 14
(5) Clearing the Imprinter Base ....................................................................................................... 15
❑ 4. Precautions ................................................................................................................................... 17
❑ 5. Error Messages ............................................................................................................................. 18
❑ 6. Specifications ............................................................................................................................... 19
❑ 7. Declarations of Conformity........................................................................................................... 20
4
Introduction
Thank you very much for purchasing the fi-434PR Imprinter Option.
This guide explains how to install and use the imprinter.
This guide also contains important information such as procedures for cartridge replacement.
Keep this guide in safety custody.
Unpack the imprinter and check that all the components listed in Table 1.1 are included.
Conventions
Important information that requires special attention is indicated as follows:
WARNING
WARNING indicates that serious personal injury may result if you do not follow a procedure correctly.
CAUTION
CAUTION indicates that minor personal injury, loss of data, or damage to the scanner may result if you do not
follow a procedure correctly.
Official Fujitsu part names are indicated with an initial capital letter, as in the part name “Pick Roller”.
NOTICE
A NOTICE provides “how-to” tips or suggestions to help you perform a procedure correctly.
5
1. Components of the Imprinter
Table 1.1 shows the imprinter components.
Table 1.1 Imprinter Components
Component
Imprinter Unit
Quantity
External View
1
1
1
1
2
Print Cartridge
Operator's Guide
Imprinter Cable
Clamp (black)
Clamp (white)
Screw
1
2
6
2. Installation
(1) Installing the Imprinter
Install the imprinter as follows:
Prepare a Phillips screw driver.
1
Turn off the scanner and disconnect the power cable.
2
(1) While pushing the lower part of the imprinter against the scanner,
(2) hang the arms on the ADF unit. Push down the ends of the arms to mount the imprinter on the scanner.
3
(1)
(2)
Move the imprinter unit to the left and secure it with
the two screws included with the imprinter
componets.
4
When removing the imprinter, reverse the installing procedures.
7
(2) Mounting the Clamps and Connecting the Imprinter cable
Two types of clamps are used for securing the imprinter cable. Mount the clamps as follows:
Note: The imprinter cable should be connected after the clamps have been mounted.
Clamps (black)
Use these clamps (black) to fix the imprinter cable.
Insert the clamps into the holes on the back of the
scanner.
1
Clamp (white)
The clamp (white) holds the imprinter cable loosely.
If the imprinter cable hangs down loosely in the way of the
paper path, use this clamp.
Place the clamp (white) at the left of the upper
imprinter shaft.
2
Connecting Imprinter cable
Fasten the imprinter cable with the clamps (black)
as shown in the bottom figure.
3
Hold the imprinter cable with the clamps (white) if
necessary as shown in the bottom cable.
4
Connect the imprinter cable to the scanner and to
the connector of the imprinter.
5
8
|