CWR-905
Wireless-N Router
Quick Installation Guide
2. Build Network Connections
Please follow the following instructions to setup wireless router:
1. Connect your xDSL / cable modem to the WAN port of router by Ethernet cable.
2. Connect all your computers, network devices (network-enabled consumer devices other than
computers, like game console, or switch / hub) to the LAN port of the router.
3. Connect the A/C power adapter to the wall socket, and then connect it to the ‘Power’ socket of the
router.
Please check all LEDs on the front panel. ‘PWR’ LED should be steadily on, WAN and LAN LEDs
should be on if the computer / network device connected to the respective port of the router is powered
on and correctly connected.
If ‘PWR’ LED is still off and you’re sure that all cable connections are connected properly, please
contact your dealer of purchase for assistance.
3. Network Setup
Please use the web browser to configure the wireless router. A computer with wired Ethernet
connection to the wireless router is required for this first-time configuration.
1. Set your computer to obtain an IP address
from wireless router: click ‘Start’ button (it
should be located at lower-left corner of your
computer), then click control panel.
Double-click Network and Internet
Connections icon, click Network
Connections, then double-click Local Area
Connection, Local Area Connection
Properties window will appear, and then
click ‘Properties’:
2. Select ‘Obtain an IP address
automatically’ and ‘Obtain DNS server
address automatically’, then click ‘OK’.
3. After the IP address setup is complete,
please click ‘start’ -> ‘run’ at the
bottom-lower corner of your desktop, then
input ‘cmd’ and click ‘OK’.
4. Input ‘ipconfig’, then press
‘Enter’ key. Please check the IP
address followed by ‘Default
Gateway’ (In this example, the IP
address of router is
192.168.1.254)
Please note that this value may
be different.
5. Start the web browser and input the IP
address of wireless router in address bar,
and the following message should be shown.
Please input user name and password, then
click ‘OK’ to access web management
interface of wireless router.
Default user name: root
Default password: 1234
6. Click ‘QuickSetup’
7. Select time zone of
the area where you
live, then click ‘Next’.
8. Select a broadband type of the Internet
connection you’re using, then click ‘Next’.
9. Please input the Internet connection
parameters, you should use the value
provided by your Internet service provider.
Click ‘OK’ when you finish.
(The content of this page will vary depends
on the connection method you selected in
step 8)
10. Click ‘Apply’.
11. When you see this message, the router
will be ready with new settings within 50
seconds.
12. Please use your computer to connect to any website on Internet, or start any Internet application
and see if they’re working properly.
For instructions of advanced settings and wireless network setup, please refer to user manual
in supplied document CD-ROM.
|
Cooper Lighting Landscape Lighting 150 1000W User Manual
Cornelius Ice Maker WCC500 User Manual
Craftsman Blower 358794964 User Manual
Crown Equipment Lawn Mower TR 3600 User Manual
Cuisinart Electric Pressure Cooker CPC 600 Series User Manual
Curtis Portable Multimedia Player MPK8065BUK User Manual
Delta Electronics Power Supply SIR136 User Manual
Edelbrock Automobile Parts 2001 PT Cruiser User Manual
Electro Voice Speaker System Eliminator ii User Manual
Estate Washer ETW4100S User Manual