SI570 IM_v1 1204 1/20/05 3:43 PM Page 1
Steam Wizard®
Professional
SI570 Instructions
Read and save these instructions.
SI570 IM_v1 1204 1/20/05 3:43 PM Page 4
SI570 IM_v1 1204 1/20/05 3:43 PM Page 5
Table of Contents
Important Safety Instructions ......................................................6
Warnings ................................................................................6
General Instructions ...................................................................9
Grounding Instructions ...........................................................9
Filling the Water Tank...........................................................12
Wet or Dry Vacuum .............................................................14
Steam or Steam Spray ..........................................................16
Cleaning...............................................................................18
Stain Removal Tips ...............................................................20
SI570 IM_v1 1204 1/20/05 3:43 PM Page 6
IMPORTANT SAFETY INSTRUCTIONS
WARNINGS
To reduce the risk of fire, electric shock
or injury when using any electrical appli-
ance, basic precautions should always
be followed, including:
•Read all instructions before using this appliance.
•This appliance operates at 120V AC and 60Hz only.
•Connect to a properly grounded outlet. Refer to grounding
instructions in this instruction manual.
•Use indoors only.
•Do not leave the appliance unattended when it is plugged in.
Unplug from outlet when not in use and before servicing.
•Do not allow the appliance to be used as a toy. Close attention
is necessary when the appliance is operated near children.
•Before using the unit as a wet vacuum, always install the
Deflector Plate.
6
SI570 IM_v1 1204 1/20/05 3:43 PM Page 7
WARNINGS
•Use only as described in this manual. Use only with the manu-
facturer’s attachments included with this unit.
•Do not use if cord or plug appears to be damaged. If the appli-
ance is not working properly, or has been dropped, damaged,
left outdoors, or dropped into water, return it to a service cen-
ter or to the original place of purchase.
•Do not pull, lift or carry by the power cord. Do not use the
cord as a handle, close a door on the cord or pull the cord
around or against sharp edges or corners.
•Connect to a properly grounded outlet. See Grounding
Instructions.
•Do not run the appliance over the cord. Keep the cord away
from heated surfaces. Do not rest the appliance on the cord
while the appliance is on or warm to the touch.
•Damaged power cord must only be replaced by qualified serv-
ice personnel. There are no user-serviceable parts inside the
unit. Any attempt to open the unit will void the warranty and
could lead to serious damage to the unit and/or personal injury
to the operator.
7
SI570 IM_v1 1204 1/20/05 3:43 PM Page 8
WARNINGS
•Turn off all controls before unplugging unit from outlet.
•Do not unplug by pulling the cord. Grasp the plug itself when
unplugging from an outlet, not the cord.
•Do not handle the plug or appliance with wet hands.
•Do not use without collection container and/or filter in place.
•Do not put any object into openings. Do not continue to use
with any opening blocked. Keep all openings free of dust, lint,
hair or anything that may reduce airflow.
•Keep hair, loose clothing, fingers and all parts of the body away
from openings and moving parts.
•Do not use to pick up anything that is burning or smoking,
such as cigarettes, matches, or hot ashes.
•Do not use to pick up flammable or combustible liquids such
as gasoline. Do not operate the unit in areas where flammable
or combustible products or vapors may be present.
•Use extra caution when cleaning on stairs.
•For household use only.
READ AND SAVE THESE INSTRUCTIONS
8
SI570 IM_v1 1204 1/20/05 3:43 PM Page 9
General Instructions
Grounding Instructions
This appliance must be properly grounded. If it should malfunc-
tion or break down, grounding provides a path of least resistance
for electric current, reducing the risk of electric shock. This appli-
ance is equipped with a cord that has an equipment-grounding
conductor and grounding plug. The plug must be inserted into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Warning: Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check with a
qualified electrician or service person if you are in doubt as to
whether the outlet is properly grounded. Do not modify the plug
provided with this appliance. If the plug will not fit the outlet,
have a proper outlet installed by a qualified electrician.
This appliance is for use in a nominal 120V circuit, and has a
grounded plug that looks like the plug illustrated in sketch A.
A temporary adapter that looks like the adapter illustrated in
sketches B and C may be used to connect this plug to a 2-pole
receptacle as shown in sketch B if a properly grounded outlet is
9
SI570 IM_v1 1204 1/20/05 3:43 PM Page 10
Grounding Instructions
not available. The temporary adapter should be used only until
a properly grounded outlet (sketch A) can be installed by a quali-
fied electrician. The rigid lug (usually green) extending from the
adapter must be connected to a permanent ground, such as a
properly grounded outlet box cover. Whenever the adapter is
used, it must be held in place by a metal screw.
10
SI570 IM_v1 1204 1/20/05 3:43 PM Page 11
Grounding Instructions
Grounded Outlet
Grounding Pin
Metal Screw
Lug for
Grounding Screw
11
SI570 IM_v1 1204 1/20/05 3:43 PM Page 12
Filling the Water Tank
Always unplug the unit and empty the water tank when not in
use. Never store the Steam Wizard with water in the tank or
plugged in to a power outlet.
1. Disconnect the Steam Wizard from the wall socket before
filling the water tank.
2. Press the TANK RELEASE TAB to remove the tank for filling.
3. Remove the water tank cap by twisting it counterclockwise.
4. Slowly pour unheated water into the opening. Leave at least
1/2 inch of air space in the water tank.
5. Replace the water tank cap by twisting clockwise until it
resists. Do not overtighten. The cap will “lock” into place as
indicated by the diagram next to the opening of the tank.
6. Return the water tank to the main housing.
12
SI570 IM_v1 1204 1/20/05 3:43 PM Page 13
Filling the Water Tank
Tank
Release Tab
13
SI570 IM_v1 1204 1/20/05 3:43 PM Page 14
Wet or Dry Vacuum
For maximum performance and product life, always empty and
clean the collection chamber and the filter after every use.
1. To activate, press the VACUUM button.
2. Glide the nozzle over the debris or spill until it has been
vacuumed into the collection chamber.
3. To turn the unit off, press the VACUUM button.
4. Do not allow the collection chamber to become too full.
5. When cleaning carpets, use the unit without attachments.
6. When cleaning hard surfaces, use with the rubber squeegee
attachment inserted into the nozzle end of the Steam
Wizard.
7. When cleaning upholstery or other fabrics, use with the
brush attachment inserted into the nozzle end of the Steam
Wizard.
14
SI570 IM_v1 1204 1/20/05 3:43 PM Page 15
Wet or Dry Vacuum
Vacuum
Button
Collection
Chamber
15
SI570 IM_v1 1204 1/20/05 3:43 PM Page 16
Steam or Steam Spray
The tank must always contain water when operating in the
Steam or Spray mode. Always test a small area of carpet or
upholstery for color fastness before cleaning with water, steam
or cleaning solutions.
1. To activate the internal heating element, press the STEAM
or SPRAY button. Allow 30 seconds for the unit to begin
producing steam.
2. For stubborn stains, the SPRAY button can be pressed to
dilute the stain with hot water. Do not over-saturate the area.
3. Glide the nozzle over the stained area until the stain is loos-
ened. Excess dirt and water can be removed by pressing the
VACUUM button and gliding the nozzle over the area.
4. To turn the unit off, press the VACUUM button.
5. Do not allow the collection chamber to become too full.
6. When cleaning hard surfaces, use with the rubber squeegee
attachment inserted into the nozzle end of the Steam Wizard.
7. When cleaning upholstery or other fabrics, use with the brush
attachment inserted into the nozzle end of the Steam Wizard.
16
SI570 IM_v1 1204 1/20/05 3:43 PM Page 17
Steam or Steam Spray
Spray Button
Steam Button
Collection
Chamber
17
SI570 IM_v1 1204 1/20/05 3:43 PM Page 18
Cleaning
Clean after each use or when the collection chamber becomes
full. The water tank must be emptied before the unit is stored.
1. Disconnect the Steam Wizard from the wall socket and hold
the unit over a wastebasket, pointing the nozzle down.
2. Release the locking tab located at the rear of the chamber.
Pull the chamber away from the unit.
3. Remove and clean the internal parts.
4. Empty the chamber by shaking it over a wastebasket. Rinse
the chamber and filter under running water to remove
remaining dirt.
5. Reassemble the unit to continue using the Steam Wizard. Once
cleaning is complete, the chamber and attachments should be
washed in warm soapy water before final reassembly and storage.
6. To empty the water tank, remove it from the main housing
and hold it over a drain. Remove the water tank cap and turn
the tank over to drain remaining water.
7. DO NOT overtighten the water tank cap when replacing it.
Tighten the cap only until resistance is felt and it cannot be
turned further without force.
18
SI570 IM_v1 1204 1/20/05 3:43 PM Page 19
Cleaning
Note: There are no user-serviceable parts.
Collection Chamber
Release Tabs
Water Tank
19
SI570 IM_v1 1204 1/20/05 3:43 PM Page 20
Stain Removal Tips
Always test-clean a small section of the stained area first. Most
cleaning agents will do damage to certain fabrics or dyes.
•For most fresh spills, remove as much liquid as possible, as quickly
as possible. Use the Steam Wizard vacuum to extract liquid from
the carpet or upholstery before preparing to steam clean.
•The exception to this is strong acids which should be flushed
with water if possible, and then neutralized by sprinkling bak-
ing soda or an ammonia solution onto the spill area. Acids are
dangerous and it may be hard to prevent some damage. Do
not vacuum acid or allow it to dry until it has been neutralized.
•Once most of the liquid is removed, there is less risk of a seri-
ous stain. Consider the best alternatives for removing the
remainder of the spill.
•Avoid mixing cleaning solutions or agents with anything other
than water. Some chemical combinations can be deadly to you
as well as to your carpet.
•Once you have removed the liquid from a spill, don’t add
water until you steam clean the area. Water will reactivate the
stain and soak it deeper into the fabric.
20
SI570 IM_v1 1204 1/20/05 3:43 PM Page 21
Stain Removal Tips
•First try to clean the spill with steam only. In most cases the
steam will eliminate the spill with the lowest possible risk of
permanent damage. Boost your cleaning power by using a
spray bottle to mist over the soiled area with a cleaning agent.
Let the mist settle on the stain for a minute, then clean with
the Steam Wizard. Use cleaning agents only as a last resort.
21
SI570 IM_v1 1204 1/20/05 3:43 PM Page 22
Stain Removal Tips
Tough Stains and Suggested Agents for Cleaning
Spray a mist of the cleaning agent into the stain. After a few min-
utes, spray-steam clean. Finish by vacuuming up any remaining
liquid. Remove all agents before they dry into fabric.
22
SI570 IM_v1 1204 1/20/05 3:43 PM Page 23
Stain Removal Tips
•Never use more than one chemical or cleaning agent on a stain.
•Use only water or steam to remove stains treated with baking soda.
•When flushing with water, vacuum up immediately. Do not soak.
23
SI570 IM_v1 1204 1/20/05 3:43 PM Page 24
One-Year Warranty
What Is Covered
This warranty covers any defects in materials or workmanship, with the exceptions stated below.
How Long Coverage Lasts
This warranty runs for one year from the date of original purchase.
What Is Not Covered
This warranty does not cover damage caused by misuse or use other than as intended and described in the
product instruction manual, or loss or damage to batteries or removable parts.
What The Sharper Image Will Do
The Sharper Image will repair any defects in materials or workmanship. In the event repair is not possible,
The Sharper Image will either replace this product with one of similar features and price, or refund the full
purchase price of the product, whichever you prefer.
How to Obtain Service
Return the product and receipt, along with a brief explanation of the problem, to:
T.S.I. - Returns Department
2901-A West 60th Street
Little Rock, AR 72209
If you have questions please feel free to contact our customer service representatives at 1-800-344-5555 or
by email at [email protected].
This warranty gives you specific legal rights, and you may have other legal rights that vary from state to state.
© 2005 Sharper Image Corporation
Sharper Image Corporation
650 Davis St., San Francisco, CA 94111
(415) 445-6000
Shop online:
Due to continuing improvements, actual product may differ slightly from the product described herein.
V1 12/04
|