RCA Car Amplifier AMP1450F User Guide

AMP1450F / AMP1450R / AMP1450FV  
Digital Signal Amplifier For Indoor Antennas  
User’s Guide  
FCC Statement:  
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause  
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC  
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment  
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause  
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.  
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to  
operate this equipment.  
Industry Canada Regulatory Information  
CAN ICES-3 (B)/NMB-3 (B)  
Avis d’Industrie Canada  
CAN ICES-3 (B)/NMB-3 (B)  
This amplifier helps enhance the performance of all passive indoor antennas. It was engineered  
specifically for digital signals. It also supports analog signals. This amplifier:  
• Enhances performance of passive antennas in challenging reception situations  
• Optimizes signal for the best possible reception through improved gain  
• Preserves signal purity with Extremely Low-Noise (ELN) circuitry  
Installing the Amplifier  
1.Make sure your TV or converter box is turned off.  
Passive  
Antenna  
2.Disconnect your antenna from your TV or converter box.  
3.Connect the cable coming from your antenna to the input jack  
of the amplifier.  
antenna  
AMP1450R  
ANTENNA  
TV/STB  
4.Connect the amplifier’s built-in cable to the antenna input on  
your TV or converter box.  
5.Plug the amplifier’s power cord into an electrical outlet.  
Important: This power unit should be plugged in so that it stays vertical  
or lies flat.  
TV  
6.Turn on your TV or converter box and re-scan for channels.  
©2013 VOXX Accessories Corporation  
3502 Woodview Trace, Suite 220, Indianapolis, IN 46268  
Trademark(s) Registered  
Printed in China  
AMP1450_IB_03  
 

Radio Shack Pager RIM 850 User Guide
Roberts Gorden Gas Heater CTH2 100 User Guide
Rotel Turntable RP 830 User Guide
Safety 1st Automobile Accessories GR0+ 1 User Guide
Samsung Home Theater System HT P38 User Guide
Samsung Washer Dryer WF B105NV C S User Guide
Sanyo Air Conditioner XHW4272R User Guide
Sanyo CRT Television DS13330, DS19330, DS25320 User Guide
SECO LARM USA Home Security System SD 8103GT PEQ User Guide
SECO LARM USA Security Camera EV 7105 NPEQ User Guide